56 Flow Control Grinder
|
56 Flow Control Grinder |
|
Model 1018 Uni. on 90" cabinet
| Key Benefits of the Crystal Lake Flow Control Grinder
The Model 56 FG Crystal Lake Flow Grinder is equipped with a cast iron base
constructed to the same standards inherent in all Crystal Lake grinders. The
base is mounted on a rugged 32” wide X 24” deep X 34” high rigid welded
heavy gauge steel cabinet with electric compartment, storage area and 15 gallon
coolant tank. (Coolant NOT included). (Coolant pump, wiring and piping for the
pump are OPTIONAL and EXTRA. Not all applications require a coolant system). COMPENSATING TABLE: Swing over table, 5”;
Distance between centers, 5-1/2”. WHEELHEAD: Spindle is angular contact
Ball Bearing Design. It includes the 220/3/60 AC Belt Drive Motor mounted on the
slide assembly with Belt enclosed in Guard. (440/3/60 AC OPTIONAL and EXTRA). HEADSTOCK: supplied with Dead Center
Driver, non-rotating Spindle, mounted Belt Drive Variable Speed Motor, Belt
enclosed in Guard. TAILSTOCK: Standard Design. STANDARD EQUIPMENT INCLUDES: Diamond
Wheel Dresser, two Carbide No. 4 Centers, Wrenches and one general purpose 7”
X 1/2” X 1-1/4” Grinding Wheel. SPECIFICATIONS: WHEEL-- 7” X ½” X 1-1/4” TABLE LENGTH-- 29” CENTER DISTANCE-- 6” ELECTRICAL-- 208-230/460 VOLTS, 3 PHASE IN-FEED-- .100” ONE TURN TABLE FEED-- DOUBLE REDUCTION COARSE: ONE TURN APPROXIMATELY ½” FINE: ONE TURN = .004” Graduations = 10 millionths of an inch |
Send mail to clg@netptc.net with
questions or comments about this web site.
|
